Rohde&Schwarz HMO 1002 series

From sigrok
Revision as of 16:49, 29 December 2016 by Gsi (talk | contribs)
Jump to navigation Jump to search
Rohde&Schwarz HMO 1002 series
RS HMO1002.png
Status supported
Source code hameg-hmo
Channels 2 analog, 8 digital
Samplerate 1GSa/s (interleaved), 500MSA/s (non interleaved)
Analog bandwidth 50/70/100MHz (software license)
Vertical resolution 8bits (HiRes up to 16bits)
Triggers pulse width, slope, video, pattern, serial bus (optional)
Input impedance 1MΩ‖16pF 200Vp CAT I
Memory 1Mpts (mode/ch-dependent)
Display 6.5" VGA (640x480), 256 colors
Connectivity USB host/device, ethernet
Features math: + / — / x / FFT, statistics, vertical sensitivity: 1mV/div - 10V/div, 4bit 50MHz pattern generator, 50kHz function generator
Website rohde-schwarz.com

The R&S 1002 Series is a 50-100MHz (software upgradable), 1GSa/s, 2 analog channel and 8 digital channel digital storage oscilloscope.

The base model can be upgraded from 50MHz to 70MHz or 100MHz with the HV572 resp HV512 option.

There are also options to decode several serial bus protocols:

  • HV110/HOO10 (S)SPI/I2C/UART, analog and/or digital channels
  • HV111/HOO11 (S)SPI/I2C/UART, analog channels only
  • HV112/HOO12 CAN/LIN decoding/triggering, analog and/or digital channels

For usage of the digital channels the HO3508 logic probe is required.

Protocol

The device use same SCPI protocol as the HAMEG HMO compact series (HAMEG has been aquired by R&S).

The device is equipped with an 100MBit/s ethernet port as well as a USB B device connector. USB can be switched from VCP (virtual COM port) to USBTMC mode via the Setup/Parameter menu. USB VID/PID is 0x0aad:0118 resp. 0x0aad:0119.

Connecting

Devices connected via USB (both VCP and USBTMC mode) are autodetected by the hameg-hmo driver, and are usable with sigrok-cli and pulseview. Devices connected via Ethernet can not be autodetected, and are thus not usable with pulseview currently, Bug#769.

$ sigrok-cli --driver=hameg-hmo:conn=/dev/ttyACM0 -O analog -C CH1 --frames 1
$ sigrok-cli --driver=hameg-hmo:conn=usbtmc/0aad.0119 -O analog -C CH1 --frames 1
$ sigrok-cli --driver=hameg-hmo:conn=tcp-raw/192.168.1.20/5025 -O analog -C CH1 --frames 1

Resources