DreamSourceLab DSLogic Plus
Revision as of 06:25, 30 March 2023 by Reversebias (talk | contribs) (Including hardware information about a new V421 variant.)
Status | supported |
---|---|
Source code | dreamsourcelab-dslogic |
Channels | 1-16 |
Samplerate | 400MHz(4ch), 200MHz(8ch), 100MHz(16ch) |
Samplerate (state) | 30MHz (?) or 50MHz (?) |
Triggers | high, low, rising, falling, edge, multi-stage triggers |
Min/max voltage | -0.6V — 6V, +-30V with provided probe-wires |
Threshold voltage | configurable: 0-5V (0.1V increments) |
Memory | 256MBit |
Compression | yes |
Website | dreamsourcelab.com |
The DreamSourceLab DSLogic Plus is a 16-channel USB-based logic analyzer, with sampling rates up to 400MHz (when using only 4 channels). This differs slightly from the original DSLogic product in its configurable threshold voltage and different PCB layout. DreamSourceLab doesn't make the distinction between these two products very clear on their website.
See DreamSourceLab DSLogic Plus/Info for more details (such as lsusb -v output) about the device.
Hardware
- Xilinx XC6SLX9 U3: Spartan-6 FPGA (TQG144BIV13337)
- Sample memory:
- Original version: Alliance AS4C16M16SA-7TCN U1: 256Mbit SDRAM
- V211: Micron MT48LC16M16A2 256Mbit SDRAM
- Cypress CY7C68013A U2: FX2LP USB interface chip
- 128Kbit I²C EEPROM U4: ST M24128-BR
- TI TPS62400 U10: Dual, Adjustable, 400mA and 600mA, 2.25MHz Step-Down Converter (3.3V and 1.2V output)
- 24.0Mhz Crystal Y1: YSX321SL series 20ppm (markings: YXC 24.0SBJI)
Hardware (V421/Pango Variant)
New hardware variant received early 2023, enumerates as 2a0e:0030, and uses a different vendor's FPGA. Currently incompatible with sigrok.
- PangoMicro Logos PGL12G U13: PGL12G, 12k LUT, LPG144 package
- Winbond W9825G6KH-6 U6: 256Mbit SDRAM
- Cypress CY7C68013A U2: FX2LP USB interface chip
- 128Kbit I²C EEPROM U4: ST M24128-BR
- Unmarked 3.3V and 1.2V regulators
- 24.0Mhz Crystal Y1: YSX321SL series 20ppm (markings: YXC 24.0SBJI)
Photos
Device:
Cables:
Firmware
See DreamSourceLab DSLogic#Firmware.