View source for Getting started with a power supply

For power supply configuration, use [[Sigrok-cli]] or [[SmuView]].

== Sigrok-cli Examples ==

Scan for device (while e.g. a [[Korad_KAxxxxP_series|Korad KA3005P]] is attached):
   sigrok-cli --driver=korad-kaxxxxp:conn=/dev/ttyACM0 --scan

Show device options (while e.g. a [[Korad_KAxxxxP_series|Korad KA3005P]] is attached):
   sigrok-cli --driver=korad-kaxxxxp:conn=/dev/ttyACM0 --show

Set output voltage (while e.g. a [[Korad_KAxxxxP_series|Korad KA3005P]] is attached):
   sigrok-cli --driver=korad-kaxxxxp:conn=/dev/ttyACM0 --config "voltage_target=3.3" --set

Enable output (while e.g. a [[Korad_KAxxxxP_series|Korad KA3005P]] is attached):
   sigrok-cli --driver=korad-kaxxxxp:conn=/dev/ttyACM0 --config "enabled=on"  --set

Get continuous readings for device (while e.g. a [[Korad_KAxxxxP_series|Korad KA3005P]] is attached):
   sigrok-cli --driver=korad-kaxxxxp:conn=/dev/ttyACM0 --continuous

Write readings to a file until you press CTRL-C (while e.g. a [[Korad_KAxxxxP_series|Korad KA3005P]] is attached):

(Note: you can open up another terminal and use "tail -f readings.log" to watch the readings as they come in)
   sigrok-cli --driver=korad-kaxxxxp:conn=/dev/ttyACM0 --continuous -o readings.log -O csv