Protocol decoder:spiflash

From sigrok
(Redirected from Protocol decoder:Mx25lxx05d)
Jump to navigation Jump to search
spiflash
Macronix mx25l1605d device top.jpg
Name SPI flash
Description xx25 series SPI (NOR) flash chip protocol
Status supported
License GPLv2+
Source code decoders/spiflash
Input spi
Output spiflash
Probes
Optional probes
Options

The spiflash protocol decoder supports the industry standard xx25 series SPI (NOR) flash chip protocol.

It is used (for example) in the Macronix MX25L1605D chip, and many others.

Hardware

Chip pinout

The Macronix MX25Lxx05D chips (and almost all SPI flash chips of the xx25 series) have the following pinout:

CS# 1-   O -8 VCC
SO 2- -7 HOLD#
WP# 3- -6 SCLK
GND 4- -5 SI

Macronix MX25L1605D in openbiosprog-spi

The spi/mx25l1605d directory in sigrok-dumps contains a set of example captures of a Macronix MX25L1605D (MX25L1605DPI-12G) SPI flash chip (16Mbit == 2Mbyte; NOR flash) that is probed, being written to, read, or erased.

The logic analyzer used was a ChronoVu LA8 (at 25MHz). It is probing the SPI chip in the openbiosprog-spi Open Hardware USB-based SPI chip programmer. The host software used is flashrom.

Probe setup:

Probe MX25L1605D pin
0 (green) CS#
1 (orange) SO/SIO1 (a.k.a MISO)
2 (white) SCLK
3 (red) SI/SIO0 (a.k.a MOSI)
4 (gray) WP#/ACC
5 (brown) HOLD#

Photos:

Protocol

The xx25 series chips uses the standard SPI protocol and pins (MISO, MOSI, SCLK, CS#), with the additional (optional) HOLD# and WP#/ACC pins.

The host can send a large number of commands to the SPI chip (such as WREN, RDID, READ, SE, CE, PP, and many more). The commands have various length, and usually consist of one command ID byte, optional address bytes, one or more data/payload bytes, and so on (depending on the command).

See the chip datasheet for a detailed protocol/register/command description.

Resources