Lcsoft Mini Board

From sigrok
Revision as of 12:36, 1 July 2012 by Uwe Hermann (talk | contribs)
Jump to navigation Jump to search
Lcsoft CY7C68013A Mini Board

The Lcsoft CY7C68013A Mini Board is a Cypress FX2 eval board, which can be used as USB-based, 16-channel logic analyzer with up to 24MHz sampling rate.

It is available on Ebay for less than €15, or Taobao for even less.

The board is fully supported by sigrok, using the fx2lafw driver.

Hardware

  • Main chip: Cypress CY7C68013A-56PVXC (FX2)
  • 3.3V voltage regulator: Advanced Monolithic Systems ASM1117-3.3
  • 128kB I2C EEPROM: Atmel AT24C128A
  • 24MHz crystal: JY24.0000601

All the pins on the FX2 are broken out to 40 header pins. There's an on/off toggle switch, a reset button, and a jumper that lets you select whether the FX2 gets its configuration from a small EEPROM, or boots into the default mode. The EEPROM's default settings make it come up with the same VID:PID as a Saleae Logic.

Photos

Possible Issues

  • With some kernel versions, and if the onboard EEPROM is disconnected (the jumper not connected) the kernel will automatically claim the device with a usbtest kernel module, seen in dmesg like usbtest 2-2:1.0: FX2 device — if this happens, sigrok will be unable to claim the device. Remove the usbtest kernel module as root to be able to use it:
$ sudo rmmod usbtest

You can add the usbtest module to a module blacklist permanently, at least in Debian-based distributions found in /etc/modprobe.d/blacklist.conf:

$ sudo sh -c "echo 'blacklist usbtest' >> /etc/modprobe.d/blacklist.conf"

Required Testing Hardware Extensions

Do not directly hook the board pins to another circuit, if you don't know what you are doing! This could damage the board!

The simplest circuit would be adding at least resistors in between your circuit-in-test and the Lcsoft board, but be aware here that the Cypress FX2 chip can only tolerate a maximum of 5V I/O. Better would be to use a clamp circuit like shown at Spiralbrain's Blog (but you do not need to add another EEPROM for sigrok with fx2lafw!). A buffer circuit using a 74HC241 IC for protection is also possible. Check the fx2lafw page to see which protection circuits are used on other logic analyzer boards.

More information can be found in Circuits for barebone boards.