Difference between revisions of "Circuits for barebone boards"
Bluesceada (talk | contribs) |
Bluesceada (talk | contribs) |
||
Line 23: | Line 23: | ||
== Analog frontends == | == Analog frontends == | ||
Designing a decent analog frontend to be used for example for [[fx2lafw]] capable devices will be a more complicated task. An appropriate ADC has to be found and an input stage with filter, protection and amplification elements needs to be designed. A possible ADC for up to 40MHz sampling frequency is the TDA 8703. | Designing a decent analog frontend to be used for example for [[fx2lafw]] capable devices will be a more complicated task. An appropriate ADC has to be found and an input stage with filter, protection and amplification elements needs to be designed. A possible ADC for up to 40MHz sampling frequency is the TDA 8703. An interesting project using that ADC with a parallel port can be found on [[http://www.volny.cz/elecon/pcoscilloscope/pcoscilloscope.html volny.cz]] | ||
An interesting DIY very high frequency probe can be found here at [http://emcesd.com/1ghzprob.htm Douglas C. Smith Web Page] | An interesting DIY very high frequency probe can be found here at [http://emcesd.com/1ghzprob.htm Douglas C. Smith Web Page] |
Revision as of 23:32, 27 June 2012
This page describes which input protection / measuring circuits for barebone or other more minimal boards can be used.
Probing a circuit
Usually for a logic analyzer high input impedance (and low capacitance) is wanted, to influence the measured circuit as least as possible (don't put an additional capacitive load on it). On the other hand, one might want to use an R-C low-pass filter for the signal to block possible higher frequency spikes. If that is wanted or required, it is best to introduce an additional buffering IC that will then drive the load of the introduced capacity of the filter. This can not directly be advised for logic analyzers, but rather for analog instruments (oscilloscopes) that will usually be used in a bigger variety of cases with possibly more noise in the signal.
Input protection
Clamp circuits with resistor / Z-Diodes
A clamp circuit can be used, view below at Spiralbrain's Blog.
Shown here again with numbering for fx2lafw pins:
For boards based on the Cypress CY7C68013A and some others it can be discussed if 4.7V or 5V Zener Diodes are also okay, as it is 5V I/O tolerant -- 5V supply can then be used from USB.
With buffer IC
Different buffer ICs can be used in combination with resistors (+ Z-Diodes to also protect the buffer IC). Depending on the IC, they can also be used for voltage-level conversion or clamping.
The 74HC241 can be driven at the measuring voltage up to 6V. Buffering can also be done by latch ICs like 74HC573 (3.3V) or 74HCT573 (5V).
Analog frontends
Designing a decent analog frontend to be used for example for fx2lafw capable devices will be a more complicated task. An appropriate ADC has to be found and an input stage with filter, protection and amplification elements needs to be designed. A possible ADC for up to 40MHz sampling frequency is the TDA 8703. An interesting project using that ADC with a parallel port can be found on [volny.cz]
An interesting DIY very high frequency probe can be found here at Douglas C. Smith Web Page